Filter
Top Products
SpectraLink 8020/8030 Wireless Telephone: Administration Guide for SRP
32 1725-36030-001_B.doc
Once the subband settings are as desired, press the Done softkey to
exit to the
Network Setup menu.
Transmit power
For subbands: The Transmit Power list opens when NavOK is
pressed from the
Subband menu. A transmit power setting is
required for each subband. Only one level may be set per
subband. Only those power levels which apply to the
regulatory domain and 802.11 mode are listed. Navigate to the
desired level and press
NavOK to set and return to the subband
list. Another subband may be selected which repeats the
process.
If the highlighted power transmit level is legal on all of the
subbands for the set mode, an
All softkey will appear. Press the
All softkey to apply that level to all subbands and return to the
subband menu where all subbands will now be selected.
All
overrides any previously set power transmit levels.
Without subbands: When the 802.11 mode has no subbands, the
Transmit Power list opens when NavOK is pressed to set the
mode. Only those power levels which apply to the domain
and 802.11 mode are listed. Navigate to the desired level and
press
NavOK. This sets the transmit power level and exits the
Regulatory Domain menus. The Network Setup menu will again
display.
Diagnostics
Run Site Survey
The Site Survey mode is activated by selecting this option. A site
survey starts running immediately upon selecting this option. See the
Diagnostic Tools section for more information about site surveys.
Diagnostics Mode
See Chapter 5, section Diagnostics Enabled for a detailed explanation of
the
Diagnostics mode options.