Samsung SCH-U450 Series Cell Phone User Manual


 
99
1.
From the
Security
menu, select
Change Lock
. You’re
prompted to enter the new lock code.
2. Enter the new lock code. You’re prompted to re-enter the
new lock code for verification.
3. Enter the new lock code again. Your new Lock Code is
stored.
Note:
Your phone does not allow you to view the Lock Code for obvious
security reasons. If you change the Lock Code, be sure to write down
or memorize the new code.
Emergency #
Your phone provides the option of storing three emergency
numbers. Each number can be up to 32 digits in length. All
emergency numbers can be manually called at any time, even
when your phone is locked or restricted. This can be a useful
feature for controlling outgoing calls from your phone.
Note:
Emergency number 911 is hard-coded into your phone. You can dial
this number any time, even when the phone is locked or restricted. If
you call 911 an audible tone is heard and an Emergency prompt
appears in the display for the duration of the call.
Important!:
Because of various transmission methods, network parameters,
and user settings necessary to complete a call from your
wireless phone, a connection cannot always be guaranteed.
Therefore, emergency calling may not be available on all
wireless networks at all times.
Important!:
DO NOT depend on this phone as a primary method of calling
911 or for any other essential or emergency communications.
Remember to always turn your phone on and check for adequate
signal strength before placing a call.
Store Emergency Numbers
1. From the
Security
menu, select
Emergency #
.
2. Select from the three emergency number entries.
3. Enter an emergency number (up to 32 digits in length).
4. Press to save the number that you entered.
Call Emergency Numbers in Lock Mode
1. In Standby mode, enter the emergency number.
2. Press to place the call.
Reset Phone
Reset Phone returns all Settings to their factory default values.
1. From the
Security
menu, select
Reset Phone
. You are
prompted to confirm that you want to restore default