Black 0018
Black0018
8. CUSTOMIZING THE CONSOLE
◆ The Console can be customized for the
specific installation.
◆ A label sheet with sensor location names is
provided with the Console.
◆ Labeling the sensors allows quick and easy
identification of where any alarms have
occurred, where a sensor with a low battery is,
where a sensor with radio trouble is, etc.
LABELING THE SENSORS
Use a paper clip to remove the clear display
window.
Bend down the tabs on the sensor number
card and fit it onto the Console.
Open one protected door/window to light its
sensor status light on the Console.
Choose a label that describes the sensor
location, or write the location on a blank label,
and stick it in the area to the right of the
sensor light.
Close the protected opening that you just
labeled.
Repeat for each protected opening.
Stick the WIRELESS KEYPAD label in the
sensor number location for the wireless
keypad (if used).
Replace the clear display window when
finished.
OPEN DOOR
OR WINDOW
TO LIGHT
SENSOR STATUS
INDICATOR
ON CONSOLE
APPLY SENSOR IDENTIFICATION
LABELS TO THE APPROPRIATE
SENSOR LOCATIONS
BEND TABS DOWN
AND INSERT IN
SLOTS
USE SENSOR
LABELS PROVIDED
WRITE IN SPECIAL
LOCATIONS ON
BLANK LABELS
16
