Black 0037
Black0037
COMMUNICATOR REPORTING OPTIONS
REPORTING FORMAT
◆ The factory setting causes the communicator
to report using the 4 by 2 format. This format
allows four-digit account numbers from 0000
to 9999 and provides two-digit alarm codes.
◆ Alternately ADEMCO CONTACT ID can be
chosen as a reporting format. This format allows
4-digit account numbers from 0000 to 9999
and provides verbose report descriptions with
Ademco Contact ID compatible Central Stations.
CALL ROUTING
◆ The factory setting for the communicator is to
route all calls to the primary telephone
number. If communication is unsuccessful
after five attempts to the primary number, the
secondary number will be dialed for an
additional five attempts. If the secondary
number cannot be reached, the communicator
will “sleep” for five minutes before starting the
call process over again. A total of five sleep
cycles (50 call attempts) can occur before the
communicator stops calling.
◆ Alternately, the communicator can be
programmed to report supervisory events (low
batteries, radio trouble, AC failure, etc.) to the
supervisory telephone number instead of the
primary or secondary telephone numbers.
✍
CAUTION: If the page alert user code feature is
going to be used, the supervisory number is
reserved for the pager number. DO NOT SET THE
CALL ROUTING OPTION TO “1”.
◆ To disable supervisory reports, set call routing
option to “1” and remove the supervisory
telephone number or in 4 by 2 set the report to “0”.
✍
NOTE: Do not program the primary and secondary
telephone numbers the same. See the FCC
Telephone Rules and Regulations on the rear
cover of this manual.
COMMUNICATOR REPORTING OPTIONS
STEP #
PROGRAMMING
FUNCTION
POSSIBLE
VALUES
FACTORY VALUE
INSTALLATION
VALUE
86 CALL ROUTING
0 = ALL CALLS TO PRIMARY OR SECONDARY NUMBER
1 = ALL ALARM CALLS TO PRIMARY OR SECONDARY NUMBER AND
ALL OTHERS TO SUPERVISORY NUMBER
0
88 ACCOUNT NUMBER 4 DIGITS EMPTY
89 PRIMARY PHONE NUMBER UP TO 20 DIGITS EMPTY
90 SECONDARY PHONE NUMBER UP TO 20 DIGITS EMPTY
91 SUPERVISORY/ PAGER PHONE NUMBER UP TO 20 DIGITS EMPTY
FOR ALL PHONE NUMBERS
⇒⇒⇒⇒
PRESSING THE (A) KEY INSERTS A 1-SECOND DELAY
THE [FIRE] KEY INSERTS A 5-SECOND DELAY
THE [CHIME] KEY INSERTS A “
*
”
THE (A) KEY INSERTS A “#” IF IT IS THE LAST DIGIT OF THE PHONE NUMBER
105 REPORTING FORMAT 0 = 4 BY 2; 1 = ADEMCO 0
108 REPORT CONSOLE TROUBLE 0 = NO; 1 = YES 0
110 REPORT FORCE ARMING 0 = NO; 1 = YES 0
111 OPEN/CLOSE 0 = NO; 1 = YES; 2 = MASTER PAC ONLY 0
113 POINT ID REPORTING FOR 4 BY 2 FORMAT 0 = NO; 1 = YES 1
Communicator Reporting Option Table
0
5
JKL
HOME
AWAY
0 FOR 4 BY 2
1 FOR ADEMCO CONTACT ID
PROGRAMMING STEP #105
PROGRAM
STORE PROGRAM
1
8
TUV
6
MNO
HOME
AWAY
PROGRAMMING STEP #86
PROGRAM
STORE PROGRAM
0 FOR ALL TO PRIMARY/SECONDARY
1 FOR ALARMS ONLY TO
PRIMARY/SECONDARY
35
