Black 0033
Black0033
ADDITIONAL USER CODES
◆ The Console can be programmed with five
restricted user codes and one page alert user code.
◆ The additional codes operate the system as
usual, but cannot access Setup Mode.
◆ The additional codes can access a special
Code Mode that can be used to change or
remove any of the five restricted user codes,
the page alert user code, or the duress code.
◆ The page alert user code dials the supervisory
number (programmed for a pager) when it is
used to disarm the system.
✍
NOTE: For maximum security, a 3-5 digit code is
recommended.
✍
WARNING: NEVER PROGRAM ANY RESTRICTED
OR PAGE ALERT USER CODE THE SAME AS THE
MASTER USER CODE!
Log the user codes in the boxes to the right.
REMOVING USER CODES
◆ Any restricted, duress or page alert user code
can be removed from the Console.
◆ Because access to programming would be
impossible without a master user code, it
cannot be removed using these steps.
◆ The master user code can be changed using
programming Step #99.
✍
NOTE: The master user code can be removed
using the Console master reset, although all other
system programming with be reset to factory
values and all sensors programmed will be erased.
CONSOLE MASTER RESET
◆ Master resetting the Console will set all of the
programming options back to the factory
values. The master user code will be reset to
1234.
✍
CAUTION: Master resetting the Console will erase
the user codes, and remove all programmed
sensors. All Console and communicator
programming values will be reset to the factory
defaults.
Start with the system in Test Mode (Setup
Mode cannot be reached from any other
mode).
From the Test Mode, enter the master user
code then press [TEST].
❇ A “Gong” and five “Beeps” will sound,
signaling that the system is in Setup Mode.
Enter programming Step #999.
Press [TEST].
Enter the numbers 999 again.
Press [TEST] again.
❇ A “Bing” will sound to indicate the beginning
of the reset process. This process will take up
to 10 seconds while the memory is being reset.
◆
The system will revert to the first time
power-up condition and the master user code
will be 1234. Go to the “Basic Console
Programming” section of this manual to begin
re-programming the system.
PROGRAMMING STEPS
#93 TO 98
PROGRAM
STORE PROGRAM
1-5 DIGIT CODE
(3-5 DIGITS RECOMMENDED)
9
WXY
TEST
KEYPAD CODE
PROGRAMMING STEPS
#92 TO 98
REMOVE
STEP # 93 RESTRICTED USER CODE #1
STEP # 94 RESTRICTED USER CODE #2
STEP # 95 RESTRICTED USER CODE #3
STEP # 96 RESTRICTED USER CODE #4
STEP # 97 RESTRICTED USER CODE #5
STEP # 98 PAGE ALERT USER CODE
START IN TEST
MASTER
USER
CODE
1 GONG &
5 BEEPS
STEP #999
FOR
MASTER
RESET
DONE
PRESS TEST,
1 BING SOUNDS,
WAIT ABOUT 10
SECONDS
TEST
9
WXY
9
WXY
TEST
9
WXY
PRESS
TEST
9
WXY
9
WXY
TEST
9
WXY
ENTER 999
TO OK THE
MASTER
RESET
USE THESE EXACT
KEYSTROKES
TO PERFORM A
MASTER RESET
31
