A SERVICE OF

logo

Open as PDF
next previous
6 - 2
No. 99MBC032A
NOTE 1. The shaded settings are the factory defaults.
2. In the above table “none parity” can not be selected if the data bits are 7 bits in
length. In this case, set the parity to either odd or even, or set the data bits to 8
bits.
TIP 1. DTR and RTS signals from the LSM will be ON immediately after power on.
2. DSR signals to the LSM are always ignored.
3. The transmitter-receiver inside the LSM uses a µPD4723 (Manufacturer: NEC).