A SERVICE OF

logo

Open as PDF
next previous
4 - 31
No. 99MBC032A
4. SETTING UP THE MEASURING CONDITIONS
4.5.3.4 F3: Setting the reference value
Set the reference value here. If “Copying the target value to the reference value” has been
specified in the basic setup, the setup guidance for the reference value will not be displayed.
In this example assume that the reference value is 12.5 mm.
PROG
Step 1: The previously set reference value is displayed.
Enter “12.5”.
1
PROG
If “1” is entered the currently displayed
setup value changes to “1”, however, it will
not be saved in memory until the
ENT
key is pressed.
2
PROG
Enter “2”.
.
PROG
Enter a decimal point (“.”).
5
PROG
Enter “5”.
PROG
Step 2: Press the
ENT
key.
The setup data will be saved in memory and the
operation automatically proceeds to the offset
value setting.