7 - 3
No. 99MBC032A
7. INSPECTION AND MAINTENANCE
7.3 Error Messages and Remedies
The table below lists the error messages and their remedies.
LASER EMISSION
Display Meaning Remedies
Segment error
• There is no measuring object that
corresponds to the specified segment.
• The shutter has been closed.
• Laser characteristic may be deteriorated.
• Check if a workpiece is present.
• Check the segment settings.
• Open the shutter.
• Check the LASER EMISSION LED.
Setup item error
• There is a certain conflict in the setup data.
• Press the key to clear the error message.
• Previously setup contents are lost. Redo setup from the
beginning.
Calibration error
• Incorrect segment setting
• A value significantly different from the dimension of
the reference gage is entered.
• The HIGH CAL setting value is too close to
the LOW CAL setting value.
• Press the key to clear the error message.
• Redo the segment setting again.
• Cancel the setting value, then set it again.
For information about the cancellation procedure,
refer to Section 4.2, "Calibration".
Setup value error:
• The upper limit value is set lower than the lower
limit value, or HIGH CAL ≤ LOW CAL.
• Input the unacceptable value.
• Clear the error message by pressing the key.
• Clear the wrong setup values and re-enter the correct
values.
Laser does not scan.
• Short-circuiting pin is not inserted in the remote
interlock connector.
• Laser diode is deteriorated.
• Scanner motor is not running.
• Insert the short-circuiting pin.
• Contact the nearest dealer or Mitutoyo sales
representative.
Laser diode anomaly
(LASER EMISSION LED is blinking.)
• The laser diode is forced to operate below
a temperature outside the specified range.
• Laser diode begins to deteriorate.
• Using the laser diode at a high temperature reduces
efficiency and accelerates deterioration in addition to
drawing a large current. Take appropriate measures to
cool the diode.
• Contact the nearest dealer or Mitutoyo sales
representative.
Internal circuit error. Contact the nearest dealer or Mitutoyo sales
representative.
C
C
C
Printer error
• Cable is not connected or broken.
• Communication conditions are not consistent.
• Check the cable connection.
Setup value error:
• Cable is not connected or broken.
• Check the cable connection.
• When the printer is not used, set to in the basic
• setup.
