6 - 5
No. 99MBC032A
6. INTERFACE UNIT
6.1.3 Printer interface
6.1.3.1 Setting the printer
• RS-232C can be set as a printer port in the basic setup mode.
• DPU-414 series printers from Seiko are compatible.
• Use a supplied connection cable which comes with the printer.
• DPU-414 series printer setup (Refer to the DPU-414 operation manual: the section 2.3,
“Functions setup” on the page 15 through 20.)
1) Software Dip Switches Setup
Set the DIP SW 1 to 3 as shown bellow.
SW1 : 1 2 3 4 5 6 7 8
0 1 1 0 1 0 1 1 (1 : on, 0 : off)
SW2 : 1 2 3 4 5 6 7 8
1 1 1 1 1 1 1 1 (1 : on, 0 : off)
SW3 : 1 2 3 4 5 6 7 8
1 1 1 1 0 1 1 1 (1 : on, 0 : off)
2) The method of Software Switches setup
a. Switch on the power while pressing the [ON LINE] key, releasing it when printing is
started. Current setup condition will be printed out.
b. Press the [ON LINE] key. “Dip SW-1” is printed out. Set the DIP SW 1: bit 1 to 8 here.
NOTE • Complete setting of DIP SW 1: bit 1 to 8 at a stretch. Don’t stop it halfway.
• [FEED] key and [ON LINE] key are assigned to “0” (off) and “1” (on) for setting
respectively.
Press both [FEED] and [ON LINE] keys in order as specified bellow.
[FEED][ON LINE][ON LINE][FEED][ON LINE][FEED][ON LINE][ON LINE]
(Print) 0 1 1 0 1 0 1 1
c. When setting DIP SW 1: bit 1 to 8 is complete in the item b., “Continue? :Push ‘On-line
SW’ ”, “Write? :Push ‘Paper feed SW’ ” will be printed out. Then press [On LINE] key to
proceed to setup DIP SW2. “Dip-SW-2” is printed out. Here, start setting of DIP SW2.
d. For DIP SW2 setting, press both [FEED] and [ON LINE] keys in order as specified
bellow.
[ON LINE][ON LINE][ON LINE][ON LINE][ON LINE][ON LINE][ON LINE][ON LINE]
(Print) 1 1 1 11111
When setting DIP SW2: bit 1 to 8 is complete, same as item c. “Continue? :Push ‘On-line
SW’ ”, “Write? :Push ‘Paper feed SW’” will be printed out. Then press [On LINE] key to
proceed to setup DIP SW3. “Dip-SW-3” is printed out. Here, start setting of DIP SW3.
e. For DIP SW3 setting, press both [FEED] and [ON LINE] keys in order as specified
bellow.
[ON LINE][ON LINE][ON LINE][ON LINE][FEED][ON LINE][ON LINE][ON LINE]
(Print) 1 1 1 1 0 1 1 1
When setting DIP SW3: bit 1 to 8 is complete, press [FEED] key. DIP SW 1 to 3 setting
will be complete.
