4 - 2
No. 99MBC032A
4.1.1 Outline of the basic setup procedure
B1 mode: a. Setting whether to perform GO/NG judgment result output in the ready state
b. Setting the display message if Err-0 occurs
c. Setting the display message at the start of measurement
d. Setting the averaging method
e. Setting the GO/NG judgment method
f. Setting whether the target value is copied to the reference value
B2 mode: a. Setting the workpiece type (opaque or transparent)
b. Setting the simultaneous measurement
c. Setting the method of specifying segments
B3 mode: a. Setting the abnormal value elimination function
b. Setting the automatic workpiece detection function
c. Setting the number of scans
d. Setting the group judgment
e. Setting the output function to the RS-232C interface
B4 mode: a. Setting the use of the RS-232C port
b. Setting the RS-232C communication baud rate
c. Setting the RS-232C communication data bits
d. Setting the RS-232C communication parity bit
e. Setting the delimiter for communication
f. Setting the RS-232C line control
B5 mode: Reserved
B6 mode: a. Setting the use of DCU
Use the and keys to switch between modes.
Basic setup mode (can be entered by pressing the key + Power ON)
Ready state
B0 mode: a. Setting the resolution
b. Setting the number of blanked out (display-off) digits
c. Setting whether a comma (",") is inserted after the thousandth digit
d. Setting the buzzer function
e. Setting the period of the display latch timer
SET
