Filter
Top Products
2 - 2
3. Remove the battery by lifting the tab.
Note: Gentle force is required to lift and remove the battery from the battery bay.
Charging the Batteries
Power for the Dolphin 6000 terminal comes from the battery pack, which is accessed from the back panel.
Before Initial Use
The terminals are shipped with the battery discharged of all power. The initial charging time for the battery pack is 4 hours.
Insert the terminal into the HomeBase or connect to the Communication Cable to charge the battery.
We recommend use of Honeywell peripherals, power cables, and power adapters. Use of any non-Honeywell peripherals,
cables, or power adapters may cause damage not covered by the warranty.
Charging Using the Communication Cable
Note: The battery may be charged (via HomeBase, USB Communication cable) as long as the temperature is between 0-40°C
(32-104° F). If the ambient temperature is less than 0° or greater than 40°C, the device runs off of battery power even if
external power is applied.
1. Slide the terminal into the cup on the USB communication cable to mate with the I/O connector.
2. Plug the power adapter cable into the power connector on the USB Communication cable.
3. Plug the USB Communication cable into the appropriate port on the host terminal.
!