Filter
Top Products
12 - 6
Connecting the Communication Cables
1. Plug in the power supply and connect it to the back of the HomeBase.
2. Plug the USB or RS232 communication cable into back of the HomeBase.
3. Connect the communication cable into the back of the workstation.
Note: At this point, the hardware is installed and operating. For USB communication, the workstation may need to be
rebooted to complete the installation process.
Establishing Communication
USB Communication
An ActiveSync connection should be auto-detected and configured when the USB connection is established.
Note: ActiveSync 4.5 or higher must be used.
RS232 communication
The RS232 port is accessed by opening COM3 on the terminal and can be used for general purpose communication
between an application running on the Dolphin 6000 and an application on a PC or a connected device.
Note: An ActiveSync connection cannot be established via RS232.