Filter
Top Products
12 - 4
Note: Signals referenced are for a DTE device. The HomeBase is at a right-angle to the printed circuit board (PCB).
Charging the Battery
The HomeBase powers the terminal and charges its battery pack in 4 hours.
The cradle knows when battery pack is fully charged and automatically changes to a trickle charge that keeps the battery at full
capacity. The terminal can stay in the HomeBase without damaging the terminal or battery packs.
Note: To check battery power, use Power menu setting; see Power on page 7-13.
For more information about Li-ion batteries, see Battery Pack on page 3-10.
To Power a Terminal and Charge its Battery
1. Install the battery pack in the terminal. Refer to Installing Battery Pack on page 2-1.
2. Connect the HomeBase to a power supply provided by Honeywell.
3. Put the terminal into the terminal well until the LED on the terminal turns red, indicating that it is charging. The battery pack
begins to charge.
Pin Description
1N/C
2TXD
3RXD
4DSR
5GND
6N/C
7CTS
8RTS
9N/C
5 4 3 2 1
9 8 7 6