Filter
Top Products
3 - 10
Honeywell also mandates use of a proper stylus, which is one that has a stylus tip radius of no less than 0.8 mm. Use of the
Honeywell stylus included with the terminal is recommended at all times.
Honeywell warranty policy covers wear on the touch panel for the first twelve (12) months if a screen protector is applied and an
approved stylus is used for the 12 month duration covered by the warranty.
Battery Pack
We recommend use of Honeywell Li-Ion battery packs. Use of any non-Honeywell battery may result in damage not cov-
ered by the warranty.
The 3.7V, 5.7W hour Li-ion battery pack is the primary power source for the terminal. The Li-ion battery is designed to operate
in a temperature range of -10°C to 50°C (14°F to 122°F).
Charging Options
Ensure all components are dry prior to placing the battery in the terminal. Mating wet components may cause damage not
covered by the warranty.
Note:The battery may be charged (via HomeBase, USB Communication cable) as long as the temperature is between 0-
40°C (32-104° F). If the ambient temperature is less than 0° or greater than 40°C, the device runs off of battery power
even if external power is applied.
If the battery is installed in the terminal, it will be charged if the terminal is in the HomeBase or if the terminal is connected
to the USB Communication cable and the AC adapter is plugged in. (The terminal cannot be charged via the USB Commu-
nication cable only.) If the battery is not installed in the terminal, it may be charged by placing it in the HomeBase’s battery
well. Use the Dolphin 6000 HomeBase (Refer to Dolphin 6000 HomeBase on page 12-1).
Charging Time
The Li-ion battery pack requires 4 hours to charge completely before initial use.
Storing Batteries
To maintain optimal battery performance, follow these storage guidelines:
• Avoid storing batteries outside the specified range of -4° to 104° F (-20° to 40°C) or in extremely high humidity.
• For prolonged storage, do not keep batteries stored in a charger that is connected to a power source.
Battery Pack Use and Disposal
The following are guidelines for the safe use and disposal of batteries.
• We recommend use of Honeywell Li-Ion battery packs. Use of any non-Honeywell battery may pose a personal hazard
to the user.
• Follow local regulations for battery disposal.
• Replace defective batteries immediately. Using a defective battery could damage the Dolphin 6000 terminal.
• Do not use a battery in any other manner outside of its intended use in the Dolphin 6000 terminal and peripherals.
• Excessive discharge damages a battery. Recharge the battery when the terminal indicates low battery power.
• Battery life is limited. Replace a battery after it is unable to hold an adequate charge.
• If you observe that the Honeywell battery supplied is physically damaged, please send it to Honeywell International Inc.
or an authorized center for inspection. Refer to Product Service and Repair on page 13-1.
• If you are not sure if the battery or charger is working properly, send it to Honeywell International Inc. or an authorized
service center for inspection. Refer to Product Service and Repair on page 13-1.
• If the battery or charger are not working properly, replace it as soon as possible.
Managing Battery Power
Default Critical and Low Battery Points
When the terminal is running on battery power (as opposed to external power), warnings are displayed when the battery
reaches critical and low battery points.
Checking Battery Power
To check the battery power:
!
!