Honeywell 6000 Cell Phone User Manual


 
4 - 2
Supported Bar Code Symbologies
Decoding
Decode a Bar Code
Point the aiming beam at a bar code. The aiming beam must align with bar code for better results. Holding the terminal
between 4-10 inches (10-25 cm) from a bar code is recommended.
1. Tap
> Demos > Scan Demo.
Note: You may activate the Vibrate option by selecting > Demos > Scan Demo > Setup > Vibrate. The device
vibrates each time a bar code is decoded.
2. Aim the scanner at the bar code.
3. Project the aiming beam by pressing and holding the SCAN key. The LED flashes red.
4. Center the aiming beam over the bar code. For optimum performance, avoid reflections by scanning the bar code at a
slight angle. To decode stacked bar codes (e.g., PDF417), slowly move the beam up or down over the code.
5. When the bar code is successfully decoded, the terminal LED flashes green and the terminal beeps. The bar code
information is entered into the application in use.
Symbology Type Symbology Name
1D Symbology Codabar
Code 3 of 9
Code 11
Code 32 Pharmaceutical (PARAF)
Code 93
Code 128
EAN with Add-On
EAN with Extended Coupon Code
EAN-8
EAN-13
GS1-128
GS1 Databar
Interleaved 2 or 5
ISBT 128
Matrix 2 of 5
MSI
Plessey
PosiCode
Straight 2 of 5 IATA
Straight 2 of 5 Industrial
Telepen
Trioptic Code
UPC
UPC-A
UPC-E