Filter
Top Products
6.Programming Features
40
Î Ringing Type
You can hear melodies.(9 melodies) You can choose Ring by pressing the
LEFT/RIGHT( ) button.
You can set as External/ Internal Ring by pressing the SET ( ) button.
Î Volume
9 volumes. You can choose volume by pressing the LEFT/RIGHT( ) button.
Display “volume set” in LCD.
2) External Ring
There are 2 menus in this menu.
z Ringing Type
z Volume
Î These menus operate in same 6.2.2.1 Ringing Set – 1) Internal Ring menu.
3) Ringing Mode
A user can select the one mode among By Ring (=Vibrator off), No Sound, By Vibrator
(=Ring off), Ring and Vib, and Ring after vib. . This function is set by Ringing Mode
setting operation in Sounds menu of Image & Sound Menu. When By Vibrator is selected,
ring tone can’t be generated. But for being conscious of incoming call there is phone
vibration. When Ring and Vib is selected, there is ring tone and vibration at the same time.
When Ring after Vib is selected, there is ring tone after 10 seconds vibration. The initial
state is Ring.
z There are five ringing mode. You can choose ring by pressing LEFT/RIGHT
( ) button and set by SET ( ) button.
Î By Ring: it generates ring sound whenever a call is incoming.
Î No Sound: No ring sound. Only ring LED is blinking.
Î By Vibrator: No ring sound. Only Vibration.
Î Ring and Vib: Ring sound and Vibration at the same time.
Î Ring after Vib: Ring sound after vibration for 10 seconds.
6.3 Phone Register
To register a new portable to your base or to register the portable again after the base reset
(see paragraph Base Reset).
6.3.1 Subscription
This function is to subscribe a wireless terminal to the system. Please refer to ‘9.2
subscription’ for details.
1) Select Subscription and press OK ( ) button.
4 bases are displayed on the LCD.
“BASE 1”,..., “BASE 4”
The base(s) where the current handset is subscribed to is (are) displayed dimly.
2) Select the desired base and press OK ( ) button.
And then “SEARCHING: x” is displayed where x means the base number.
If the handset searches the base, the base RFPI is displayed in the handset.
3) Press OK ( ) button.
And then AC: is displayed.
z Enter the AC and press OK ( ) button, then the handset subscription is finished.
From now on, “Range Out” is disappeared on the LCD in the idle mode.