Filter
Top Products
7.Key System Functions
47
7. Key System Functions
7.1 Call Park
A user can park using intercom call or CO line to CO line parking location.
7.1.1 Call Park
While connected to an outside call;
1) Press TRANS ( ) button shorter than 1 second.
2) Dial a parking location.
3) The intercom call or CO line being used is on hold and the wireless terminal goes to an
idle state.
7.1.2 Retrieving a parked call
1) Press
TALK
( )
or
Accept
( ) button.
2) Dial the parked location.
7.1.3 Parking Location Number
SYSTEM PARKING LOCATION NUMBER
ipLDK-24 601~608
ipLDK-100 601~610
ipLDK-300/300E 601~619
7.2 Call Back
When you dial to a station that is busy or in DND mode, you can leave a call back indication
message up to 5.
7.2.1 Call Back in case of Dialing to a Station in Busy State
1) After receiving intercom busy tone, press
CALL BACK
( ) button.
Note
If the busy station earlier goes to an idle state before pressing button, the called
station will have a message from the system. About the message, see the below “Answer a
Message Waiting Indication”.
When the busy terminal is idle, a reserved user’s terminal for call back will be ringing.
1) Answer the ring by pressing
TALK
( ) button.
7.2.2 Call Back in case of Dialing to a Station in DND Mode or No Answer
1) If you receive intercom busy tone or there is no answer after dialing to a station, press
CALL BACK
( ) button.
2) Then, if VMIB is installed in the system, a voice message is heard. Press “#” button to
leave a message. If you want to stop leaving a message, press
END
( ) button. And if
VMIB is not installed in the system, only a station message is left in the system for the
called station.
3) A message icon is displayed in 3 minutes on the LCD of a reserved user’s station for call
back.
4) If a call back message is displayed on the LCD, press
TALK
( ) or
INT
( )
button shorter than 1 second and then press
CALL BACK
( ) button to make a call
to a station leaving a message.