Filter
Top Products
6.Programming Features
46
6.5.8 S/W Version
Selecting this sub-menu displays current software version on the LCD.
6.5.9 Edit Co Code
A user can edit 4 CO access codes for each system.
This means CODE-1 is for Base 1, CODE-2 is for Base 2 and CODE-4 is for Base 4. It is used
when you select CO code to “yes” in phonebook. In the case of “yes”, you need not insert CO
access code like ‘0’ in a telephone number. Automatically, this code number will be added for
outgoing call.
Please, input the first CO line access code like '0' or '9' for each system. It is not recommended
to input CO line access group code like '8801'. If you do not use the first CO line access code,
you can not see matched phonebook name when you receive an incoming call from a system. It
is because system sends a CID including the first CO line access code for GDC-400H.
6.5.10 Missed Call Mode
In the case of ring group, sometimes handset can get too many missed calls when other keyset
answers an incoming call. If you do not want to display “XX missed calls” on the LCD in the
case, you can disable to display missed call count by this menu.
6.5.11 Range Out beep
You can enable and disable a beep tone when handset is located in the range out area. If you
enable this feature, you will hear beep tone every 3 seconds when you go to a location where
system signal can not be reached for longer than 1 minute. When you go out of office all day
long with wireless terminal, this warning feature will help for you not to forget to turn it off.
6.5.12 Clock Display
This function adjusts the clock display enable or disable on the idle screen. If you’d like to
receive time information from your system automatically and see the clock information on the
screen, please select ‘Yes’ in this menu and just do offhook and onhook on the phone. Then
you can see the same time on the screen of the phone as the system.
1) Select Clock Display and press the OK ( ) button.
2) Change the clock display state to Yes or No with the LEFT/RIGHT ( ) buttons, and
then press the OK ( ) button.
Model Applied version
LDK-50/100/300/600
MPB
LDK-24
From version 3.7
WTIB From version 1.0O
WTIBE From version 1.0Ba
GDC-400H From version 1.0Ac
6.6 Direct Call
Emergency call is named. In set up mode, number is transmitted input any key.
1) Select Direct Call and press the OK ( ) button.
2) Change the Direct call setting between Yes and No with the LEFT/RIGHT ( )
buttons, and then press the OK ( ) button.
3) If you select Yes, you can change the direct phone number, and then press the OK
( ) button.