Filter
Top Products
9. Installation of Wireless Terminal
62
At the Wireless Terminal
Menu ( ) + Select Phone Register menu + Select Subscription + Select empty
BASE + AC code + OK ( )
1) Press Menu ( ) button.
2) Main Menu is displayed on the LCD.
3) Select Phone Register menu by pressing Navigation ( ) button and OK ( )
button.
4) Phone Register menu is displayed on the LCD.
5) Select “Subscription” by pressing
UP/
DOWN
(
) button and
OK
( ) button.
6) Select empty BASE number and press OK ( ) button.
7) A user needs not to input PARK value. The wireless terminal tries to search for the
registrable system and “Searching..x” is displayed on the LCD. After locking into the
system, a RFPI is displayed on the LCD. Press OK ( ) button if the RFPI of system is
what your want to subscribe. Else, press No ( ) button to make wireless terminal to
search next system.
8) Enter AC code for subscription.
9) Press OK ( ) button.
10) Success or failure of the subscription is notified with confirmation tone to the attendant
and the wireless terminal.
11) If succeeded in subscription, the wireless terminal displays “Subscription Done” and its
station number is displayed when you put wireless terminal into idle state.
12) If failed, repeat 3) ~ 6) steps of the attendant and 1) ~ 8) steps of wireless terminal.
Note
1. According to the system or radio channel environment, the system or the wireless
terminal may not recognize that the system has the subscribed wireless terminal or the
wireless terminal is subscribed to the system. Once a user has done subscription, try to
make a call
first. Then, if a user can’t make a call, try to subscribe the wireless terminal again after
doing local desubscription that is described in the following chapter.
2. If a user wants to subscribe the wireless terminal in Auto mode, it is recommended to
remove all DECT systems except the system which the user want to subscribe to.
3. When a user tries to subscribe the wireless terminal continuously (in case of multiple
subscription) in Auto mode or when the wireless terminal is reset (power reset or change
of subscribed system), it is recommended to wait about 20 seconds, after that the
wireless terminal is locked to the system and RSSI icon stops blinking, in order to try next
subscription.