Filter
Top Products
Tools
103
Copyright © 2006 Nokia. All rights reserved.
unsuccessful call attempt. To stop automatic redialling,
press .
Summary after call—Activate this setting if you want the
device to briefly display the approximate duration of the
last call.
Speed dialling—Select On, and the numbers assigned to
the speed dialing keys ( - ) can be dialed by pressing
and holding the key. See also ‘Speed dial a phone number’,
p. 32.
Anykey answer—Select On, and you can answer an
incoming call by briefly pressing any key under the slide
cover.
Line in use (network service)—This setting is shown only if
the SIM card supports two subscriber numbers, that is, two
phone lines. Select which phone line you want to use for
making calls and sending text messages. Calls on both lines
can be answered irrespective of the selected line. If you
select Line 2 and have not subscribed to this network
service, you will not be able to make calls. When line 2 is
selected, is shown in the standby mode.
Tip! To switch between the phone lines, press and
hold in the standby mode.
Line change (network service)—To prevent line selection,
select Line change > Disable if supported by your SIM
card. To change this setting, you need the PIN2 code.
Connection
Data connections and access points
Your device supports packet data connections ( ), such
as GPRS in the GSM network.
Glossary: General packet radio service (GPRS) uses
packet data technology where information is sent in
short packets of data over the mobile network.
To establish a data connection, an access point is required.
You can define different kinds of access points, such as:
• MMS access point to send and receive multimedia
messages
• Access point for the Web application to view WML or
XHTML pages
• Internet access point (IAP) to send and receive e-mail
Check the type of access point you need with your service
provider for the service you wish to access. For availability
and subscription to packet data connection services,
contact your network operator or service provider.
Packet data connections in GSM and UMTS
networks
When you use your device in GSM and UMTS networks,
multiple data connections can be active at the same time
and access points can share a data connection. In the
UMTS network, data connections remain active during