Filter
Top Products
Tools
105
Copyright © 2006 Nokia. All rights reserved.
Access point name (for packet data only)—The access
point name is needed to establish a connection to the
packet data and UMTS networks. You obtain the access
point name from your network operator or service provider.
User name—The user name may be needed to make a data
connection, and it is usually provided by the service
provider. The user name is often case-sensitive.
Prompt password—Select Yes if you must enter a new
password every time you log in to a server, or if you do not
want to save your password in your device.
Password—A password may be needed to make a data
connection, and it is usually provided by the service
provider. The password is often case-sensitive.
Authentication—Select Normal or Secure.
Homepage—Depending on what you are setting up, write
the Web address or the address of the multimedia
messaging centre. Complete the Advanced settings to
further define your access details:
Network type—Select the Internet protocol type to use:
IPv4or IPv6. The other settings depend on the selected
network type.
Phone IP address (for IPv4)—Enter the IP address of your
device.
DNS address— Primary DNS address, Second. name
server: Contact your Internet service provider to obtain
these addresses.
Glossary: The domain name service (DNS) is an
Internet service that translates domain names such as
www.nokia.com into IP addresses like
192.100.124.195.
Proxy serv. address—Define the address for the proxy
server.
Proxy port number—Enter the proxy port number.
SIP settings
SIP (Session Initiation Protocol) settings are needed for
certain network services using SIP, such as video sharing.
You may receive the settings in a special text message
from your network operator or service provider. You can
view, delete, or create these setting profiles in SIP
settings.
Data call
The data call settings affect all access points that use a
GSM data call.
Online time—Set data calls to disconnect automatically
after a time-out if there is no activity. To enter a time-out,
select User defined, and enter the time in minutes. If you
select Unlimited, data calls are not disconnected
automatically.