Filter
Top Products
Settings
115
Copyright © 2007 Nokia. All rights reserved.
WLAN network mode—Select Ad-hoc to create an ad hoc
network and to allow devices to send and receive data
directly; a wireless LAN access point device is not needed.
In an ad-hoc network, all devices must use the same
WLAN network name.
WLAN security mode—Select the encryption used: WEP,
802.1x (not for ad hoc networks), or WPA/WPA2. If you
select Open network, no encryption is used. The WEP,
802.1x, and WPA functions can be used only if the network
supports them.
WLAN security settings—Enter the settings for the
selected security mode:
Security settings for WEP:
• Wep key in use—Select the WEP key number. You can
create up to four WEP keys. The same settings must be
entered on the wireless LAN access point device.
• Authentication type—Select Open or Shared for the
authentication type between your device and the
wireless LAN access point device.
• WEP key settings—Enter WEP encryption (length of
the key), WEP key format (ASCII or Hexadecimal), and
WEP key (the WEP key data in the selected format).
Security settings for 802.1x and WPA/WPA2:
• WPA/WPA2—Select the means of authentication: EAP
to use an extensible authentication protocol (EAP)
plug-in, or Pre-shared key to use a password.
Complete the appropriate settings:
• EAP plug-in settings (only for EAP)—Enter the
settings as your service provider instructs.
• Pre-shared key (only for Pre-shared key)—Enter a
password. The same password must be entered on the
wireless LAN access point device.
• WPA2 only mode (only for WPA/WPA2)—Select
whether Temporal Key Integrity Protocol (TKIP) is used.
Homepage—Define a home page.
Select Options > Advanced settings and from the
following:
IPv4 settings: Phone IP address (the IP address of your
device), Subnet mask (the subnet IP address), Default
gateway (the gateway), and DNS address. Enter the IP
addresses of the primary and secondary DNS server.
Contact your internet service provider for these addresses.
IPv6 settings > DNS address—Select Automatic, Well-
known, or User defined.
Ad-hoc channel (only for Ad-hoc)—To enter a channel
number (1-11) manually, select User defined.
Proxy server address—Enter the address for the proxy
server.
Proxy port number—Enter the proxy port number.