Filter
Top Products
Programmable Settings
52 For assistance, please visit http://www.panasonic.com/phonehelp
Line mode
Generally, the line mode setting should not
be adjusted.
When another phone connected to the
same line is in use, and
–if k or l is not displayed on the
handset, or
–if {LINE1} or {LINE2} button light is off
on the base unit,
you need to change the line mode to “A”.
LYou only need to program this setting
once, using either the handset or base
unit.
1 {MENU} (center of joystick) i h i
{SELECT}
2 “Set tel line” i {SELECT}
3 “Set line mode” i {SELECT}
4 Select the desired line.
5 Select the desired setting. (Default: “B”)
i {SAVE} i {OFF}
1 {MENU} i h i {SET}
2 “Set tel line” i {SET}
3 “Set line mode” i {SET}
4 Select the desired line.
5 Select the desired setting. (Default: “B”)
i {SET} i {STOP}
Changing the PIN (personal
identification number) o
For security, the PIN must be entered
when changing certain settings such as
registering units. The default setting is
“7262”.
Important:
LIf you change the PIN, please make note
of your new PIN. The unit does not
reveal the PIN to you.
1 {MENU} i h i {SET}
2 “Set PIN” i {SET}
3 To change the PIN for the first time, skip
to step 4.
To change the PIN, enter the current 4-
digit PIN. i {SET}
4 Enter the new 4-digit PIN. i {SET}
5 Enter the new 4-digit PIN again. i
{SET} i {STOP}
If you forget the PIN (resetting the base
unit to its default settings)
If you set the PIN and you cannot
remember it, you can reset the base unit
using the following procedures.
Base unit:
{MENU} i {MUTE} i
{#}{9}{0}{0}{0}
Note:
LThe following items are reset to their
default settings:
– Settings checked in the base reset
column on page 93
– Answering system: On
– Line selection for answering system:
Line 1 and line 2
LIf you have registered a cellular phone,
the following cellular phone settings are
also reset to their default settings.
–“Assign Base/HS” (Allows you to
select which unit to ring for cellular
calls, page 69): “All”
Handset
Base unit
TH102-C.book Page 52 Monday, March 13, 2006 2:41 PM