Filter
Top Products
71
3.
To create a new connection, touch .
– or –
To edit the existing AT&T MMS, touch this entry.
4. Select the parameter you want to edit:
• Set Name
: enter a profile name.
• Access Name
: edit the access point name.
• Auth Type
: select the type of authentication used for this WAP
connection: None, Normal, or Secure.
•User ID
: enter the User ID required to connect to the network.
• Password
: enter the user password required to connect to the
network.
•Protocol
: set the connection protocol used by the WAP browser:
WAP, HTTP, or Other.
•Home URL
: enter the URL address of the page to be used as your
homepage.
• Proxy Address
: MEdia Net set as the proxy server address and
port.
• Linger Time (sec.)
: set a time period (in seconds) after which the
network is disconnected if there has been no new data traffic in that
time.
• Advanced Settings
: allows you to configure some of the IP-specific
information: Static IP, Static DNS, Server information, and Traffic
Class.
–
Static IP
: specify if you want to manually enter an IP address. If you
want the IP address to be automatically assigned by the server, remove
the check mark.
–
Static DNS
: specify if you want to manually enter the Domain Name
Server (DNS) address. If you want the address to be automatically
assigned by the server, remove the check mark.
–
Traffic Class
: select the traffic class.
Note:
The WAP settings may vary depending on the service provider.
5. Touch to store these new settings.
IMS Settings
IMS is the method used to connect to the server in order set up
the Video Share option.
1. From Idle mode, touch ➔
Settings
➔
Connectivity
➔
IMS Settings
.
2. Touch one of these options:
• IMS Service
allows you to set the IMS service to
On
or
Off
.
Touch to store the new setting.
Create
Save
Save
a867 Eternity.book Page 71 Tuesday, October 14, 2008 10:42 AM