Filter
Top Products
PROGRAMMING PROCEDURES-INTRODUCTION
SECTION 100-816-301
MARCH 1993
TABLE 1 -E
PROGRAM 03
SLOT ASSIGNMENTS
Press...
Step
BUHONS
+ LED keys
(DK16 ONLY)
#
Action description
LCD RESPONSE . . .
1. Use an LCD digital or electronic telephone with a
NO.
OF STATION (10 - 29)
programming template.
JAN 20 SUN
06:43
2. *.#*#1*2*3
PROGRAM MODE
Enter programming mode.
3. SPKR 0 3 HOLD
PROGRAM = 03
Access Program 03. After SPKR key is pressed, system
DATA STORE
beeps to indicate program number may be entered.
4. SPKR 03 SELECT =
Prepare system for a selection.
5.
Enter a PCB slot number (00-07).
03 SELECT = (00 - 07)
CARD = Default code will
The system defaults as follows:
appear here
00
03 SELECT = 00
Initialized data assigns CTU slot 00 to be non-optioned,
CARD = 91
-SLOT NUMBER
without a K4RCU.
01
03 SELECT = 01
Initialized data assigns DKU slot 01 to be non-optioned
CARD = 61
-SLOT NUMBER
without a door phone or DDSS console.
02
03 SELECT = 02
Initialized data assigns fixed KCOU slot 02 with code Il.
CARD = 11
-SLOT NUMBER
03
03 SELECT = 03
Initialized data assigns fixed KSTU slot 03 with code 31.
CARD = 31
-SLOT NUMBER
04-07
03 SELECT = 04 - 07.
Initialized data assigns Expansion Unit’s universal slots
CARD = 00
LSLOT NUMBER
04 - 07 to be empty, code 00.
6.
00-92
03 SELECT = (00 - 07)
Dial the PCB code recorded on the record sheet. CARD = (00 - 92)
Refer to the PCB code reference table on Program 03
System Record Sheet for a definition of the codes.
7.
HOLD
03 SELECT = (00 - 07)
Secure data in system programming.
DATA PROGRAMMED
8.
SPKR 03 SELECT =
Prepare system for another selection (go back to
step 5), or exit Program 03 (continue with step 9).
9.
# # HOLD
03 SELECT = ##
Secure Program 03 data in system memory.
DATA PROGRAMMED
10.
SPKR PROGRAM =
Exit Program 03. Enter another program number, or exit
programming mode (go to step 11).
System beeps to indicate it’s exiting Program 03.
11.
# # HOLD
NO. OF STATION (10 - 29)
Exit programming mode.
JAN 20 SUN
06:58
12.
In order to secure Program 03 entries, POWER OFF
for 5 seconds, then POWER ON.
l-11