Filter
Top Products
PROGRAMMINGPROCEDURES-INSTRUCTIONS/SYSTEMRECOROS
SECTION lOO-816-302
MARCH1993
LCRCOLINEPROGRAMING
1) Use Program 16 to assign CO lines in groups per the reference chart below.
CO Line Group Reference Chart
NOTE: Shaded areas apply to DK16 only
I
Line Group
I
CO Lines in
Group (1 - 8)
CO Line Type/Comments
I
2 (82)
I
I
3 (63)
I
4 (64)
I 5 (85)
6 (86)
7 (67)
r 8 (88)
2) Use Program 40 to allow CO lines access to stations using LCR for outgoing calls.
3) Use Program 41 to deny outgoing CO line access except for LCR access.
Important: Area code and office code structure must be defined by Program 45-7
(Toll Restriction Dial Plan) for LCR to work properly.
4) Use Program 45-1 to enable the dial plan that is appropriate for the area where LCR calls will originate.
PROGRAM50-1
LCRPARAMETERS
Press Button/LEDs for each LCR parameter.
LED X LED On LED Off
1 Enable System LCR No LCR
2 Not Used Not Used
3 555 LDI Route Per Program 50-4 Per Area Code Table
4 Dial Tone After LCR Access Silent
5 Warning Tone Last Choice Route No. No Warning Tone
NOTES:
1. For more information, see the instructions preceding the record sheets.
2. Program 40 denies CO line access via LCR and denies all other access methods.
3. Program 41 allows CO line access via LCR but denies all other outgoing access methods:
(CO line number 701 - 708, Pooled group 81 - 88, Line or Pooled Line Grp buttons).
4. Initialized data: All LEDs OFF.
5. To prevent Toll Restriction from being defeated because of K4RCU or QRCU time-out, Toll Restrictedstandard
telephones should be forced to dial outgoing calls via LCR.
2-113