Filter
Top Products
PROGRAMMING PROCEDURES-INSTRUCTIONS/SYSTEM RECORDS
SECTION 100-816-302
MARCH 1993
PROGRAM 42-O
CO LINE TO PBX/CENTREX CONNECTION
pJq--qqppJ-q-~~~-~-~
SELECT = 0 7- TSpecify CO lines by setting
Button/LEDs as defined by
the table below.
NOTE: Shaded areas apply to DK16 only
NOTES:
1. For more information, see the instructions preceding the record sheets.
2. Initialized data reads all LEDs OFF for all CO lines.
3. This progam must be utilized to allow CENTREWPBX (after flash) features to operate.
4. If CO line is programmed for behind CENTREXIPBX (LED ON), re-seize guard time is 1.5 seconds. If CO line
is programmed for normal operation guard time is 0.45 seconds. See Program 10-1, LED 02.
2-80