Filter
Top Products
PROGRAMMINGPROCEDURES-INSTRUCTIONS/SYSTEMRECOROS
SECTION 100-816-302
MARCH1993
PROGRAM 15
ASSIGNING DP/DTMF, TENANT SERVICE TO INDIVIDUAL CO LINES
p-p-j~lT;lT;lpq-pq-fJjpq-p-pl
SELECT =Program Code
Buffon/LEDs = CO Line J
Specify CO lines by setting LEDs, as defined by the table below.
All LEDs with an “x” should be lit when finished.
NOTE: Shaded areas apply to DK16 only
I I I
I
CO Lines 01 - 08
als IButtonlLEDs1 I
I I
Program
Code Program
\ I
OFF (ii)
02 03 04 05 06 07 08
UN
(02) (03) (04) (05) (06) (07) (08)
0
AR VM Calls/D Detect
Ton&%73
Ignore
1
CO Outgoing Signal5
CO Dial Pulse Rate
(Pulse per sec.)
AR Hold/Ring
Transfer3$8
AR Timing3
Tandem CO Line
Connection with Station
Drooout4
6
CO Line Tenant Tenant 2 Tenant 1
Assignment
7 Forced Account Code Equipped Not Equipped
I 8
1 Operation After Flash 1 No QRCU 1 QRCU/K4R(
-a-.. XI--L ^Y^” ZI^^L
NOTES:
1. For more information, see the instructions preceding the record sheets.
2. Initialized data is all LEDs Off.
3. AR = Automatic Release signal. This is a momentary open of the CO line loop provided by some Central Offices. If pro-
grammed to recognize AR, CO lines on-hold will drop when the outside party hangs up and the CO sends AR signal. Two
CO line DISA calls always release with AR. DISA line release is not related to this program-DISA calls always release with
AR signal. AR is sometimes referred to as “Calling Party Control” or “Supervised Loop Control.”
4. Tandem connection must be equipped for all DISA CO lines and all other lines used for two CO line conference.
5. If a CO line is set for Dial Pulse (DP) operation, the Tone Dial Select button must be programmed on stations that must send
DTMF tones over the CO lines. (See Program 39 to assign feature buttons.)
6. When AR is sent on a CO line call because the outside caller hangs-up, “D”tone will be sent to the voice mail (VM) port (QSTlJ/
PSTLYPESLYKSTU), prompting the VM machine to release and clear the port for another call.
7. The system will detect the AR signal (auto release) and drop the voice mailpot? when the outside caller hangs up. (See Note
3 for AR explanation.)
8. If the CO line is enabled to detect AR, the CO line will disconnect anytime during a call if the Central Office sends the AR signal.
If AR is sent when talking on a CO line with an LCD telephone, the LCD will display, “CO LINE HANG UP.”
9. See Program 10-1, LED 14, to select DK8 dial pulse rate.
2-57