Filter
Top Products
PROGRAMMING PROCEDURES-INSTRUCTIONS/SYSTEM RECORDS
SECTION 100-816-302
MARCH 1993
PROGRAM 90
INITIALIZING PROGRAMS 00 - 97
LEDs 01 and 02
must be lit
Program 90
LEDs 01 and 02
must flash
IMPORTANT
Initialize Programs 00 - 97 every time :
l
A new system is installed
l
To bring a system’s programming back to the default setting
Specify the range as follows:
L!iiEElmm
To initialize one program at a time, just enter the individual
program number, then #.
NOTES:
1. Always complete Program 90 at new system installs, before
programming anything else. Skipping this step may cause erra tic
system behavior.
2. Follow instructions in Table 1-C (Section 100-816-301) to clear this
data.
3. When Program 90 is run, it will initialize any program or range of
Programs without cycling system power.
WARNING!
Running this program will erase customer data.
2-44