Filter
Top Products
PROGRAMMINGPROCEDURES-INSTRUCTIONS/SYSTEMRECORDS
SECTION lOO-816-302
MARCH1993
PROGRAM 12
SYSTEM ASSIGNMENTS - BASIC TIMING
SELECT = 3-9 - -
SELECT CODE = Enter required
Enter program code,
code for the time listed in the
3 - 9, from table below.
table below. See Note 3.
bogram Code
Function
Time
Required
Code
36
46
5
Pause Timing
(Speed Dial)
Flash Timing4
Pause After Flash
(Voice Path Delay)
QRCU or
K4RCU Inter-digital
Release Time
(Standard Phone)
q
1
0 2
q
1
0 2
q
4
0 0
q
1
0 2
q
1
1.5 sec.
3.0 sec.
0.5 sec.
2.0 sec.
0.2 sec.5
no pause
1.5 sec.
3 sec.
1 sec.
9
through
through
9 sec.
NOTES:
1. For more information, see the instructions preceding the record sheets.
2. Initialized data programs timing as follows: Code 3 = 1, Code 4 = 2, Code 5 = 0, and Code 9 = 4.
3. When programming Code 9, the LCD responds with “LINE TIME =” instead of ‘SELECT CODE =.”
4. The duration of time the CO line circuit opens Tip & Ring when the Flash button is pressed or when
the hookflash code Cnf/Tm Q 5 is dialed.
5. This timing is not normally used in the United States.
6. This timing applies to voice calls originated from telephones and voice or data calls originated by Data
Interface Units, PDIU-Dl(2)s or PDIU-DSs.
2-55