Filter
Top Products
PROGRAMMINGPROCEDURES-INTRODUCTION
SECTION lOO-816-301
MARCH1993
TABLE 1-G
PROGRAM 04
Press...
PORT AND STATION NUMBER ASSIGNMENT
Step
BUTTONS
+ LED keys
I, /\ntir\n rlnc.,-srintinn
T.PlT DRCDAXTCR
K
r\bII”I I UG33b1 lprlvl I YLY .LXYYL “&.YY . . .
1. Use an LCD digital or electronic. telephone with a NO. OF STATION (10 - 29)
programming template.
JAN 20
SUN
06:43
2.
*#*#1+2*3
PROGRAM MODE
Enter programming mode.
3. SPKR 0 4 HOLD
PROGRAM = 04
Access Program 04. System beeps after SPKR
DATA STORE
is pressed to indicate a program number may be entered.
4. SPKR
04 SELECT =
Prepare system for a selection.
5. OO#-19#
04 SELECT = 00
Select the number of the logical port (use two digits), then #.
INT = IO
Initialized data assigns station numbers 10 - 19 DK8 or
10 - 29 DK16.
6. ~~~~
04 SELECT = 00 - 19
Enter the port’s station number from the record
INT = XXXX
sheet (four digits max.).
NOTE:
Station numbers must not exceed four digits, or
conflict with feature access codes listed in Program
05 System Record Sheet.
7. HOLD
Secure data in system programming.
8. SPKR
Prepare system for another port selection (go back
to step 5), or exit Program 04 (continue with step 8).
04 SELECT = (00 - 19)
DATA PROGRAMMED
04 SELECT =
9. ##HOLD
Secure Program 04 data in system memory.
10. SPKR
Exit Program 04. Enter another program number,
or exit programming mode (go to step 10).
04 SELECT = ##
DATA PROGRAMMED
PROGRAM =
System beeps to indicate it’s exiting Program 04.
11. ##HOLD
Exit programming mode.
NO. OF STATION (10 - 29)
JAN 20 SUN
06:58
1-14