xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
The following fields can then be set in either the Add or Modify 802.1Q Static VLANs windows:
Parameter Description
Unit
Select the unit you wish to configure.
VID (VLAN ID)
Allows the entry of a VLAN ID in the Add window, or displays the VLAN ID of an existing
VLAN in the Modify window. VLANs can be identified by either the VID or the VLAN name.
VLAN Name
Allows the entry of a name for the new VLAN in the Add window, or displays the VLAN name
in the Modify window.
Advertisement
Enabling this function will allow the Switch to send out GVRP packets to outside sources,
notifying that they may join the existing VLAN.
Port Settings - Allows an individual port to be specified as member of a VLAN.
Tag
Specifies the port as either 802.1Q tagging or 802.1Q untagged. Checking the box will desig-
nate the port as Tagged.
None
Allows an individual port to be specified as a non-VLAN member.
Egress
Select this to specify the port as a static member of the VLAN. Egress member ports are ports
that will be transmitting traffic for the VLAN. These ports can be either tagged or untagged.
Forbidden
Select this to specify the port as not being a member of the VLAN and that the port is
forbidden from becoming a member of the VLAN dynamically.
Click Apply to implement changes made.
VLAN Trunk
This window is used to configure VLAN trunk settings.
To view this window, click L2 Features > VLAN > VLAN Trunk, as shown below:
Figure 3- 7. VLAN Trunk Global Settings window
The following parameters can be configured:
Parameter Description
VLAN Trunk
Status
Use the pull-down menu to enable or disable VLAN trunk global status.
State
Use the pull-down menu to enable or disable VLAN trunk port state.
Member Ports
Enter the ports for VLAN trunk. Tick the All Ports check box to select all ports.
Click Apply to implement the changes.
96
