xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
Link Aggregation
This table is used to configure port trunking on the switch.
To view this table, click L2 Features > Trunking > Link Aggregation, as shown below:
Figure 3- 27. Link Aggregation Group Entries window
To configure port trunk groups, add a new trunk group and use the Link Aggregation Group Configuration window (see
example below). To modify a port trunk group, click the Hyperlinked Group ID. To delete a port trunk group, click the
corresponding
under the Delete heading in the Link Aggregation Group Entries window.
Figure 3- 28. Link Aggregation Group Configuration window
The user-changeable parameters are as follows:
Parameter Description
Group ID
Select an ID number for the group, between 1 and 32.
Type
This pull-down menu allows you to select between Static and LACP (Link Aggregation Control
Protocol). LACP allows for the automatic detection of links in a Port Trunking Group.
State
Trunk groups can be toggled between Enabled and Disabled. This is used to turn a port
113
