xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
Figure 4- 64. OSPFv3 Area Table window
To search for an entry by Area ID, click the Find button.
To display all Area entries, click the View All button.
To remove an entry from the table, click its corresponding
under the Delete heading.
To add an OSPFv3 Area to the table, type a unique Area ID (see below) select the Type from the drop-down menu. For a Stub
type, choose Enabled or Disabled from the Stub Summary drop-down menu and determine the Metric. Click the Add button to
add the area ID set to the table.
To remove an Area ID configuration set, simply click
in the Delete column for the configuration.
To change an existing set in the list, type the Area ID of the set you want to change, make the changes and click the Modify
button. The modified OSPFv3 area type will appear in the table.
See the parameter descriptions below for information on the OSPFv3 Area Tables window. To remove an entry from the table,
click its corresponding
under the Delete heading.
The Area ID settings are as follows:
Parameter Description
Area ID
A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx) that uniquely identifies the
OSPFv3 area in the OSPFv3 domain.
Type
This field can be toggled between Normal and Stub using the pull-down menu. When it is
toggled to Stub, the additional field Stub Summary will then be capable of being configured.
Stub Import
Summary LSA
Displays whether or not the selected OSPFv3 Area will allow Summary Link-State
Advertisements (Summary LSAs) to be imported into the area from other areas.
Stub Default Cost
Displays the default OSPFv3 cost for the route to the stub of between 0 and 65,535. The
default is 1.
Clicking the Add button will reveal the following window to configure:
Figure 4- 65. OSPFv3 Area Settings - Add window
225
