xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
Figure 2- 52. DHCP Relay Option 60 Add window
The following parameters may be configured:
Parameter Description
String
Enter the specified string, up to a maximum of 255 alphanumeric characters.
Server IP
Enter the relay server IP address.
Match Type
Use the drop-down menu to select either Exact Match or Partial Match.
Exact Match – The option 60 string in the packet must fully match the specified string.
Partial Match – The option 60 string in the packet only needs to partially match the specified
string.
Click Apply to implement the changes. To return to the DHCP Relay Option 60 Table window, click the Show DHCP Relay
Option 60 Table link.
DHCP Relay Option 61 Default Settings
This window is used to configure the DHCP Relay Option 61 Default Settings. These settings are used to determine the rule to
process those packets that have no option 61 matching rules.
To view this window, click Administration > DHCP/BOOTP Relay > DHCP Relay Option 61 Default Settings, as shown
below:
Figure 2- 53. DHCP Relay Option 61 Default Settings window
The following parameters can be configured:
Parameter Description
DHCP Relay Option
61 Default
Use the pull-down menu to choose either Relay or Drop. When drop is specified, the packet
with no matching rules found will be dropped without further process. When relay is selected
the packet will be relayed based on the relay rules.
Enter the IP Address of the entry you wish to configure.
Click Apply to implement the changes.
53
