D-Link Systems DGS-3600 Manual

next previous

xStack

DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch

DHCP/BOOTP Relay Interface Settings

This window allows the user to set up a server, by IP address, for relaying DHCP/ BOOTP information to the Switch. The user

may enter a previously configured IP interface on the Switch that will be connected directly to the DHCP/BOOTP client using the

following window. Properly configured settings will be displayed in the table at the bottom of the following window, once the

user clicks the Add button under the Apply heading. The user may add up to four server IPs per IP interface on the Switch.

To view this window, click Administration > DHCP/BOOTP Relay > DHCP/BOOTP Relay Interface Settings, as shown

below:

Figure 2- 49. DHCP/BOOTP Relay Interface Settings window

The following parameters may be configured or viewed.

Parameter Description

Interface

The IP interface on the Switch that will be connected directly to the Client.

Server IP

Enter the IP address of the DHCP/BOOTP server. Up to four server IPs can be configured per IP

Interface