xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
Basic LLDP Port Settings
The following window is used to set up LLDP on individual port(s) on the Switch.
To view this window, click L2 Features > LLDP > Basic LLDP Port Settings, as shown below:
Figure 3- 66. Basic LLDP Port Settings window
The following parameters can be set or displayed:
Parameter Description
Unit
Select the desired stacking unit, if applicable.
From/To
Select a port or group of ports using the pull-down menus.
Notification State
Used to configure each port for sending notification to configured SNMP trap receiver(s).
Enable or disable each port for sending change notification to configured SNMP trap
receiver(s) if an LLDP data change is detected in an advertisement received on the port from
an LLDP neighbor. The definition of change includes new available information, information
timeout, and information update. In addition, the changed type includes any data update
/insert/remove.
149
