xStack
®
DGS-3600 Series Layer 3 Managed Gigabit Ethernet Switch
Interface Settings
The IP Address may initially be set using the console interface prior to connecting to it through the Ethernet. If the Switch IP
address has not yet been changed, read the introduction of the DGS-3600 Series CLI Reference Guide or return to Section 4 of
this manual for more information. To change IP settings using the Web manager users must access the IP Address window
located in the Administration folder.
The Web manager contains two folders for which to set up IP interfaces on the switch, one for IPv4 addresses, named IPv4
Interfaces Settings, and one for IPv6 addresses, named IPv6 Interfaces Settings.
NOTE: After properly configuring an IP interface on the Switch, each
VLAN can be routed without any additional steps.
IPv4 Interfaces Settings
To view this window, click L3 Features > Interface Settings > IPv4 Interfaces Settings, as shown below:
Figure 4- 1. IPv4 Interface Settings window
To remove an entry from the table, click its corresponding
under the Delete heading.
To manually assign the Switch's IPv4 address and its related configurations, click the Add button, revealing the following window
to configure:
Figure 4- 2. IPv4 Interface Settings – Add window
To modify an existing Interface, click that interface’s Modify button, which will produce this window:
173
