General Operation 55
Figure 2.7.1—Display of numerical test data
To use the data feature, select it as your DISPLAY in the menu:
1. Press [MENU].
2. Select DATA/GRAPH using the [
∨, ∧] keys.
3. Set DATA using the [<, >] keys.
4. Press [EXIT].
To see the numerical data of an existing curve, press [F2] to select desired curve.
To gather new information, press [START/STOP], and a new curve will be run,
updating the data table once the measurement is complete. If you are using the
composite or fast sweep signal, the information will continue to be refreshed
with each new measurement until you push [START/STOP] again.
When the LONG signal source is selected and a distortion measurement is
turned on, the data tabulation will not show the last four frequencies of the
sweep. The last frequency displayed is 6500 Hz. The last four sweep frequen-
cies 6700, 7100, 7500, and 8000 Hz will not be displayed.
2.7.2 Curve ID Box
The curve ID box provides you with lots of useful information about the curves.
It has three main columns: # (curve number), SRC (source), and TYP (type).
