Changing pre/post routing
The Pre/Post-Fader Send button in the Sends control region and the Pre/Post Fader Insert FX button in the Faders control region
work together to determine the signal flow for your busses.
The Pre/Post Fader Insert FX button allows you to indicate whether the insert FX chain is affected by the channel's gain fader. When set
to Post Fader Insert FX , the FX chain is affected by the channel’s gain. When set to Pre Fader Insert FX , the FX chain is not affected
by the channel’s gain fader, which is essential on the master bus when using plug-ins that dither the audio for final rendering.
The Pre/Post Fader Send button allows you to create cue mixes that are not affected by the gain (or mute/pan) stages of the bus or
track.
• When Pre Fader Insert FX and Pre Fader Send are selected, your audio signal flows as follows: bus effects — bus send — bus
pan — bus volume.
• When Pre Fader Insert FX and Post Fader Send are selected, your audio signal flows as follows: bus effects — bus pan — bus
volume — bus send.
• When Post Fader Insert FX and Pre Fader Send are selected, your audio signal flows as follows: bus send — bus pan — bus
volume — bus effects.
• When Post Fader Insert FX and Post Fader Send are selected, your audio signal flows as follows: bus pan — bus volume — bus
effects — bus send.
Using Input Busses
You can use input busses to input, process, record, and mix external audio sources with your ACID project. Following are some
examples of how you can use input busses in your projects:
• Use an input bus as a recording input, allowing you to apply effects and record a wet signal.
• Use an input bus as a mixer input for an external device, such as a synthesizer.
• Use an input bus as a return for hardware-based effects.
• Use an input bus to monitor a source such as a talkback microphone.
Adding or deleting input busses
From the Insert menu, choose Input Bus (or click the Insert Input Bus button in the Mixing Console window) to add an input bus to
your project.
You can add up to 26 input busses, and you can change the number of busses at any time.
Adding a bus
From the Insert menu, choose Input Bus to add an input bus to your project.
Tip:
If the Mixing Console Window is visible, click the Insert Input Bus button .
Renaming a bus
To rename a bus, double-click the label at the bottom of the channel strip and type a new name in the box (or press F2 to rename the
selected bus). The channel strip in the Mixing Console is updated when you press Enter:
Delete all characters in a custom bus name to reset a custom bus name to its default.
168 | CHAPTER 10
