Filter
Top Products
54 Chapter 3
Utility Procedures
Oscilloscope
Selecting the Oscilloscope’s Input
1. Press Shift, then RF Anl (AF Anl) to select the AF ANALYZER screen.
2. Select the AF Anl Input field. A list of choices appears.
3. Select the desired input to the scope:
• FM Demod for FM demodulated audio from input signals
connected to the RF IN/OUT or ANT IN connectors.
• AM Demod for AM demodulated audio from input signals
connected to the RF IN/OUT or ANT IN connectors.
• SSB Demod for SSB demodulated audio from input signals
connected to the RF IN/OUT or ANT IN connectors.
• Audio In for a signal connected to the AUDIO IN connector.
• Ext Mod for a signal connected to the rear panel MODULATION
INPUT connector.
• FM Mod for the FM modulated audio from the RF generator
section.
• AM Mod for the AM modulated audio from the RF generator
section.
• Audio Out for the signal present at the AUDIO OUT connector.
4. The input to the oscilloscope is displayed on the SCOPE screen.
Selecting the Oscilloscope’s Filters
1. Press Shift, then RF Anl (AF Anl) to select the AF ANALYZER screen.
2. Select the Scope To field. A list of choices should appear.
3. Select the desired filtering for the signal:
• Input if you want no filtering (dc coupled)
• Filters to route the audio to the oscilloscope after passing through
filters 1 and 2. (ac coupled)
• De-emp to route the audio to the oscilloscope after passing
through filters 1 and 2, and the de-emphasis circuitry.(ac coupled)
• Notch to route the audio to the oscilloscope after passing through
Filters 1 and 2, the de-emphasis circuitry, and notch filter
circuitry. (ac coupled)
Main Menu