Filter
Top Products
Chapter 3 69
Utility Procedures
Using Channel Numbers to Set Analyzer and Generator Frequencies
Chapter 3
Utility Procedures
RF Chan and Tune Freq Fields
NOTE All of the test procedures in this document assume you are using
channel tuning. If you are using frequency tuning, enter the frequency
in the appropriate field(s).
When you use channel tuning, the RF ANALYZER and RF
GENERATOR screens displays an RF Channel field for entering the
channel to tune to or generate.
When you use frequency tuning, the RF ANALYZER screen replaces
the RF Channel field with the Tune Freq field for direct frequency
entry. The RF GENERATOR screen replaces the RF Channel field
with the RF Gen Freq field. For AMPS Base Station tests, remember
that there should always be a 45 MHz separation between the transmit
and receive frequencies (transmit frequency is 45 MHz greater than the
receive frequency).
Main Menu