Nokia C7FRSTYMET Cell Phone User Manual


 
Nickel
Note: The surface of this device does not contain nickel
in the platings. The surface of this device contains stainless
steel.
Protect your device from harmful content
Your device may be exposed to viruses and other harmful
content. Take the following precautions:
Be cautious when opening messages. They may contain
malicious software or otherwise be harmful to your
device or computer.
Be cautious when accepting connectivity requests,
browsing the internet, or downloading content. Do not
accept Bluetooth connections from sources you do not
trust.
Only install and use services and software from sources
that you trust and that offer adequate security and
protection.
Install antivirus and other security software on your
device and any connected computer. Only use one
antivirus application at a time. Using more may affect
performance and operation of the device and/or
computer.
If you access preinstalled bookmarks and links to third
party internet sites, take the appropriate precautions.
Nokia does not endorse or assume liability for such
sites.
Operating environment
This device meets RF exposure guidelines in the normal use
position at the ear or at least 1.5 centimeters (5/8 inch) away
from the body. Any carry case, belt clip, or holder for body-
worn operation should not contain metal and should position
the device the above-stated distance from your body.
To send data files or messages requires a quality connection
to the network. Data files or messages may be delayed until
such a connection is available. Follow the separation distance
instructions until the transmission is completed.
Vehicles
Radio signals may affect improperly installed or inadequately
shielded electronic systems in motor vehicles such as
electronic fuel injection, electronic antilock braking,
electronic speed control, and air bag systems. For more
information, check with the manufacturer of your vehicle or
its equipment.
Only qualified personnel should install the device in a vehicle.
Faulty installation or service may be dangerous and may
invalidate your warranty. Check regularly that all wireless
device equipment in your vehicle is mounted and operating
properly. Do not store or carry flammable liquids, gases, or
explosive materials in the same compartment as the device,
its parts, or accessories. Remember that air bags inflate with
great force. Do not place your device or accessories in the air
bag deployment area.
Switch off your device before boarding an aircraft. The use of
wireless devices in an aircraft may be dangerous to the
operation of the aircraft and may be illegal.
Potentially explosive environments
Switch off your device in any area with a potentially explosive
atmosphere. Obey all posted instructions. Sparks in such
areas could cause an explosion or fire resulting in bodily
injury or death. Switch off the device at refueling points such
as near gas pumps at service stations. Observe restrictions in
fuel depots, storage, and distribution areas; chemical plants;
or where blasting operations are in progress. Areas with a
potentially explosive atmosphere are often, but not always,
clearly marked. They include areas where you would be
advised to turn off your vehicle engine, below deck on boats,
chemical transfer or storage facilities and where the air
contains chemicals or particles such as grain, dust, or metal
powders. You should check with the manufacturers of
vehicles using liquefied petroleum gas (such as propane or
butane) to determine if this device can be safely used in their
vicinity.
Wet or dusty conditions
Important: Accessories for use with this device are not
as durable or water-resistant as the device. For example,
chargers should only be used in dry conditions, never when
damp or wet.
Water-resistance means resistance against cold, clean
fresh water only. Do not expose the device to any other
type of liquid, such as sea water.
Do not submerge your device in water.
If the device has been exposed to water, wipe it off with
a dry cloth. If it has been exposed to any other liquid,
immediately splash some clean fresh water onto the
device. Wipe the device carefully dry.
Do not charge the device or connect anything to the
connectors if they are dusty, wet, or damp.
If the connectors are dusty, open the connector cover
of the device and splash clean freshwater onto the
connectors to remove the dust. Wipe the device and
connector area dry carefully, and let the inside of the
connectors dry.
Only open the back cover in dry and clean conditions,
and wipe the device dry and clean before opening the
back cover to prevent water or dust from reaching the
interior of the device. Make sure the interior of your
device and the back cover seals are dry, clean, and free
of any foreign objects, as they may damage the seals
against water.
Certification information (SAR)
This cellular device meets guidelines for exposure to
radio waves.
Product and safety information 79