Filter
Top Products
If you need any further advice, please call our Technical Helpline on 020 8758 0338 (Mon-Fri)
Network key:
Setup Wizard
123
123 - JONES
Confi guration
16
Connecting to your computer network - cont.
WEP keys are 10 or 26 characters long (using 0 - 9, and A - F). Press the '123'
button, then press again when it shows 'hex'. This provides a simplifi ed keyboard
layout for the WEP key entry. Some wireless routers can also use pass-phrases
for WEP but these are not supported.
WPA keys are usually set up using a pass-phrase of between 8 and 63 characters.
Your radio accepts pass-phrases for WPA keys.
19. To enter the WEP or WPA key, characters see page 11. Enter characters as
needed until the complete key has been entered. Remember, WEP keys only
use the numbers 0-9 and letters A-F. WPA keys are sensitive to upper and lower
case characters. You must enter the key exactly or the radio will not connect to
the network.
After the fi nal character of the WEP or WPA key has been entered touch the tick
symbol. The screen will show 'Connecting...' and then 'Setup wizard completed'.
Touch OK to exit the setup wizard. The radio should now be able to connect to
the network.
20. Once you have connected your radio to the network (and therefore also to the
Internet) it will go into Standby mode. It should then display the time as obtained
from the Internet. If the time display is not correct for any reason, it can easily be
adjusted later, see page 70, 'Manually setting the clock'.
Setup Wizard
Setup wizard completed.
OK
15:09 23 Jun 2010
09:00
Thurday 15 Jul