Filter
Top Products
192
3. Aim your device at the TV and tap (
Power
) to
confirm the set up process completed successfully and
the correct TV IR codes were selected.
Note:
The process of the initial TV activation can take up to 10
seconds. Please do not press the button again.
4. If the TV turned on, tap
Yes, this code 1 works
.
– or –
If the TV did not turn on after tapping (
Power
) and
waiting 10 seconds, tap
No, test next code 2
or
Send this code 1 again
.
5. From the
Select your channel source
screen, select the
entry that corresponds to your current channel control
method:
• Set-top Box
: selected when changing channels is done via a
receiver box. Channels are not changed via the TV remote but
rather through the receiver/box.
• My xxx TV
: selected when a signal is fed directly into the TV
and no box is used. Channels are changed directly on the TV by
using the TV remote and not a box’s remote.
Note:
Try matching your current channel selection method.
6. Select the Satellite Box Brand from the available list.
For example, DirectTV
®
.
•
If your brand does not appear in the list, tap
Show other
brands
and follow the on-screen instructions.
Important!
You must configure your set top box for IR
communication with your device. If you do not
select
More info
below and follow the on-screen
instructions you may not be able to properly use
the application.
7. When prompted to Enable IR, tap
More info
to learn
how to configure your set top box to receive and
respond to IR controls.
8. Only after completing the IR setup process and
programming your box, press .
Note:
This IR programming of your set top box is a one-time
process and once successful should not need to be
repeated.