Filter
Top Products
Introduction 8
3. Replace the cover by lining up the tabs and then firmly
sliding the cover away from the lens until it snaps into
place.
Replacing the Battery
If there is a need to replace the pre-installed battery, follow these
instructions.
Warning!:
Do not handle a damaged or leaking Li-Ion battery as this action
can result in being burned.
1. Make sure the device is powered off. For more
information, refer to “Powering Off your Device” on
page 4.
2. In a single motion, press down on the cover and slide it
away from the lens and then carefully lift the battery cover
away from the device.
3. Slide your finger into the removal grooves (1) and carefully
remove the previous battery from the battery compartment
(2).
SWD-M100.book Page 8 Tuesday, July 21, 2009 2:44 PM