Support User Manuals

Sierra Wireless 20070914 Cell Phone User Manual

Open as PDF

of 203

Configuration Commands

Rev 3.0B Feb.08 119

*NETIP?

Note: If there is no current

network IP address, 0.0.0.0 may

be displayed.

ThecurrentIPaddressofthemodemreportedbytheinternal

module,generallyobtainedfromAT&T.Thisistheaddress

cancontactthePinPointXfromtheInternet.

Tip: Use *NETALLOWZEROIP if you need to allow the display of an

IP ending in a zero.

*NETOP?

Thecurrentcellularcarrierfromthemodemʹsfirmware

version,forexample,AT&T.

*NETRSSI?

ThecurrentRSSI(ReceiveSignalStrengthIndicator)ofthe

PinPointXasanegativedBmvalue.

Tip: The same information is displayed with the command S202?.

*NETSERV?

Thetypeofservicebeingusedbythemodem,forexample

Tech.

*NETSTATE?

Thecurrentnetworkstate:

• ConnectingToNetwork:ThePinPointXisintheprocess

oftryingtoconnecttothecellularnetwork.

• NetworkAuthenticationFail:Authenticationtothe

cellularnetworkhasfailed.Verifysettingstoactivatethe

PinPointX.

• DataConnectionFailed:ThePinPointXfailedtoconnect,

anditisnowwaitingasettimeintervalbeforeitattempts

toreconnect.VerifysettingstoactivatethePinPointX.

• NetworkNegotiationFail:Networkconnectionnegoti‐

ationfailed.Thisisusuallytemporaryandoftenclearsup

duringasubsequentattempt.

• NetworkReady:ThePinPointXisconnectedtothe1x

cellularnetworkandreadytosenddata.

• NetworkDormant:ThePinPointXisconnectedtothe1x

cellularnetwork,butthelinkisdormant.Itwillbewoken

upwhendataissentorreceived.

• NoService:Thereisnocellularnetworkdetected.

previous next