Support User Manuals

Sierra Wireless 20070914 Cell Phone User Manual

Open as PDF

of 203

Configuration Commands

Rev 3.0B Feb.08 140

address,thecellularconnectionwillbeclosed(sincetheIP

addresshaschanged)andhastobere‐initiated.(default).

• n=1:PrivateIPMode:WhentheHostinitiatesa1x

connection,thehostwillbegiventheIPaddressspecified

in*HOSTPRIVIP.Themodemwillthenperform1to1

NAT‐likeaddresstranslation,whichshieldstheHostfrom

networkIPchanges.

*HOSTPW=string

HostPasswordforPAP ,CHAP,orPPPoE.

• string=password

*HOSTUID=string

HostUserIDforPAP ,CHAP,orPPP oE.

• string=userid(upto64bytes)

PassThru

PassThruModeisusedtocommunicatedirectlytothe

PinPointXinternalhardware.

Caution: While the modem is in PassThru mode, ALEOS is disabled.

If you need to connect to the PinPoint X while it is in PassThru mode,

you will need to do so with a terminal application. Not all commands

are available while the modem is in PassThru mode.

Figure 1-13: AceManager : PassThru

\APASSTHRU

Note: This mode is not available

through the remote AT telnet

server. You will need to connect

to the PinPoint X with it

connected directly to your

computer.

Setsthemodemoperationtopassthroughmode.Thismode

willpassanycharactersreceivedontheportEthernetdirectly

totheinternalhardwaremoduleandoutputanycharacters

fromtheinternalhardwaremoduleouttheportEthernet.This

allowsdirectaccess/configurationofthehardwaremodule.

Oncethismodeisentered,

theunitmustbephysicallyresetto

returntonormaloperation.Thiscommandisnotavailablein

AceManager.

previous next