Support User Manuals

Sierra Wireless 20070914 Cell Phone User Manual

Open as PDF

of 203

Data Communication and Host Modes

Rev 3.0B Feb.08 61

• SLIPMode:ThePinPointXusesSLIPtocommunicate

withadeviceorcomputerconnectedtotheserialorUSB

port.

• UDPandUDPPAD:Anydatareceivedontheserialport

isassembledintoUDPpacketsandsenttothesession’s

associatedIPaddressandPort(describedlater).Any

responsesreceivedfromtheassociatedIPaddressandport

destinedfortheDevicePortareunwrappedandsentout

theserial

port.

• TCPandTCPPAD:Anydatareceivedontheserialportis

packagedintoTCPmessagesandsenttotheassociated

connection’sIPaddressandPort(describedlater).Any

datareceivedfromtheTCPpeerisunwrappedandsent

outtheserialorEthernetport.

Data Communication

• PublicandPrivateModes:Themethodusedbythe

PinPointXtopassanIPaddresstoaconnecteddevice.

• Keepalive:HowthePinPointXmaintainsitsconnectionto

thecellularnetwork.

Basic Modes

Start up Mode

TheserialportofthePinPointXcanbeconfiguredtoenterany

ofthemodesautomaticallyonpowerup(inmostcases,thisis

alsoafterithasregisteredonthecellularnetwork).Thisis

donebysettingtheStartupModeDefaulttothedesiredmode.

Ifthissettingis

non‐zero,themodemwillenterthespecified

modeafter5seconds.Ifyouwanttocancelthisbehavior,the

ATMD0commandcanbeusedbeforethe5‐secondtime‐out

expires.

YoucanconfiguretheStartupModeinAceManageratpartof

theUDPgroup.

previous next