Support User Manuals

Sierra Wireless 20070914 Cell Phone User Manual

Open as PDF

of 203

Configuration Commands

Rev 3.0B Feb.08 123

• d.d.d.d=IPaddresstocontact

• ppppp=porttocontact

Examples:

ATD - Dial (establish) default connection.

ATDP192.168.13.31/2332 - Dial (establish) UDP session to

192.168.13.31, at port 2332.

Toendtheconnection,issuethe+++escapesequenceordrop

theDTRline(ifIgnoreDTRS211=0or&D2).Thedefault

connectionissetinS53.

Ifthemethod,IPaddress,orportisomitted,thevaluesfrom

S53areused.Ifatelnetconnectionisrequested(N)andthe

portisnotsupplied,port23willbeusedinsteadofthevalue

fromS53.

Ifadomainnameisspecified,theʹ@ʹsymbolcanbeusedto

explicitlyindicatethestartofthename.Forexample,if

ATDPHONYisissued,thiswillbeinterpretedasdialaUDP

connectionto“HONY”.Todialusingthedefaultmethodto

host“PHONY”,onewouldissueATD@PHONY.

Severalspecialdialingnumbersexisttomakeiteasyto

establishaPPPorSLIPconnectionwiththemodem.

ATD#19788orATDT#19788willestablishaPPPconnection

(see\APPP)andATDT#7547willestablishaSLIPconnection

(see\ASLIP).

Tip: The source port of the session is the Device Port (set by S110 or

*DPORT).

DS=n

AllowsaPPPconnectiontobeinitiatedonthehostport.

• n=2:InitiatesthePPPconnection.

CannotbeconfiguredinAceManager.

Hn

Hang‐UpCommand.

• n=1:Hang‐up

WithanATtelnetconnection,thiscommandwillterminatethe

hostdatamodeandreturnthePinPointXtoanATmode.

CannotbeaccessedinAceManager.

O

Online(Remote):CausestheRaventogofromCommandState

todatastate.CannotbeconfiguredinAceManager.

previous next